Laminated Steel Padlocks

Laminated Steel Padlocks for Lockers and General Security

These laminated steel padlocks provide a practical keyed locking solution for lockers, cabinets, toolboxes and other storage equipment fitted with a compatible padlock hasp or locking eye. Alternative shackle lengths allow the padlock to be matched more closely to the position and clearance of the locking point.

When choosing a padlock, the most important consideration is not simply the overall size of the lock. The shackle must pass freely through the hasp or locking point, provide enough clearance for the padlock body and allow the lock to close without being forced or placed under sideways pressure.

Choosing the Correct Shackle Length

Use the shortest shackle that comfortably passes through the intended locking point and allows the padlock to close correctly. A longer shackle can be useful where the hasp is recessed, where access around the fitting is restricted or where additional reach is needed between the padlock body and the locking point.

Before ordering, measure the locking point and the available space around it. Compare these measurements with the exact shackle and body dimensions shown in the specification section below.

Using a Laminated Padlock on a Locker

A laminated padlock can be used with a locker where the door is fitted with a padlock-compatible hasp. This arrangement allows the user to secure the locker with a removable padlock rather than relying on a permanently fitted keyed or combination lock.

Check that the locker hasp opening will accept the padlock shackle and that there is sufficient clearance around the door, handle and frame. This is particularly important when replacing an existing padlock or selecting a lock for a locker with a recessed locking point.

Typical Applications

Laminated steel padlocks are suitable for a broad range of everyday security applications where a compatible hasp or locking eye is provided, including:

• school, workplace and staff lockers;
• gym and leisure centre lockers;
• storage cabinets and cupboards;
• toolboxes and equipment storage;
• workshop and maintenance storage; and
• general commercial and institutional storage.

Padlock Fit and Security

Correct fit is important. Excessive clearance can allow unnecessary movement, while a shackle that is too short may not pass through the locking point or may prevent the padlock from closing correctly. The locking point itself should also be strong enough for the level of security required, because a padlock can only secure the fitting to which it is attached.

For unusually shaped fittings, restricted access or applications where the padlock will be exposed to demanding environmental conditions, confirm compatibility before ordering rather than selecting a padlock solely by body size.

Choosing Between a Padlock and a Fitted Locker Lock

Padlocks are useful where users are expected to provide or retain their own removable lock. A permanently fitted locker lock may be more appropriate where keys, access codes or user management need to remain under the control of the site operator.

Total Locker Service supplies both padlocks and dedicated locker locking systems, allowing the locking method to be selected according to the locker design, user access requirements and level of control required by the facility.

Laminated Steel Padlock FAQ